Friction and Wear Testers

Rotating Drum / Both-Way Sliding Combined Friction and Wear Tester

With this instrument, both-way slide testing and wear tester can now both be tested with one instrument. Not only does this benefit both parties, but the wear testing has also become more simplified. The H34's automatic both-way movement has a maximum of 9,999,999 movement number of times. This system also utilizes a dedicated chucking jig as its drum roller fixing method and has rotation direction/speed of 50-500rpm.

SKU H34 Category Friction and Wear Testers

$54,900.00

Rotating Drum System

Used to inspect friction between a rotating surface and sheets, the H16 can be used for textile, film and paper measurement, as well as assessing friction and wear characteristics of coated or plated surfaces (on the drum). The sheet of test material is placed over 1/8 to 1/2 of the drum's diameter. A load is applied to the sheet and the other end connected to a strain gauge. When the drum rotates, friction occurs and its resistance is detected and displayed.

SKU H16 Category Friction and Wear Testers

$48,500.00

Scratch Tester

Scratch resistance is calculated as the result of continuous loading. A scratch needle is loaded onto the test surface. The mobile base holding the test piece travels with the applied load. When the scratch or film peeling begins, the vertical load can be calculated as the distance to the failure point can be precisely measured. Various needle diameters and materials can be used to properly test almost any surface. Scratch hardness an be measured by using a fixed load instead of the continuous load module. This system includes an analog output and PC data collection system.

SKU H18L Category Friction and Wear Testers

$22,700.00

Scratch Tester

OBS - This instrument has been replaced by our H18L Scratch resistance is calculated as the result of continuous loading. A scratch needle is loaded onto the test surface. The mobile base holding the test piece travels with the applied load. When the scratch or film peeling begins, the vertical load can be calculated as the distance to the failure point can be precisely measured. Various needle diameters and materials can be used to properly test almost any surface. Scratch hardness can be measured by using a fixed load instead of the continuous load module. This system does not have an output module

SKU H18 Category Friction and Wear Testers Tag obsolete

$17,500.00

Static Friction Tester

Install a test piece onto the ascending board under the flat indentor. The ascending board is equipped with a sensor that monitors the motion of the flat indentor. The ascending board is normally in the horizontal position. The board inclines and the sensor detects motion when the flat indentor starts sliding. The system is then stopped and the angle is measured to calculate the coefficient of static friction.

SKU H10 Category Friction and Wear Testers

$12,500.00

Surface Property Tester

Benchtop low cost surface property tester including a 1000gf loadcell, Sapphire needle(0.05R 90 degrees x 1), Vertical gauge for sapphire needle(1), a set of combination deadweight, Power cable(1), Acrylic resin cover(1), Parts box(1), Tool spanner(1) and Operating instruction manual(1). Commissioning and Tribosoftware w/PC are not included. The set of combination deadweight includes 200gx1, 100gx2, 50gx1, 20gx1, 10gx2, 5gx1, 2gx1 and 1gx1.

SKU H38 Category Friction and Wear Testers

$28,900.00