Rotating Drum / Both-Way Sliding Combined Friction and Wear Tester
With this instrument, both-way slide testing and wear tester can now both be tested with one instrument. Not only does this benefit both parties, but the wear testing has also become more simplified. The H34’s automatic both-way movement has a maximum of 9,999,999 movement number of times. This system also utilizes a dedicated chucking jig as its drum roller fixing method and has rotation direction/speed of 50-500rpm.
$54,900.00
Additional
| Weight | 120 lbs |
|---|---|
| Dimensions | 31 × 20 × 30 in |
Related Products
-
Wide-Range Load Friction and Wear Tester
$94,500.00Now with it’s wider range measurement range, the H35 allows for testing from a minimum of 20g to a maximum of 100kg. This allows for optimal rotational wear testing due to its ability to address low and high speeds. The H35 can conduct a single test up to a maximum of 9,999,999 times. The H35 also utilizes a non-contact type of thermometer with an interlocking system as its opening and closing type (safety cover).
-
Scratch Tester
$17,500.00Scratch resistance is calculated as the result of continuous loading. A scratch needle is loaded onto the test surface. The mobile base holding the test piece travels with the applied load. When the scratch or film peeling begins, the vertical load can be calculated as the distance to the failure point can be precisely measured.
Various needle diameters and materials can be used to properly test almost any surface. Scratch hardness can be measured by using a fixed load instead of the continuous load module. This system does not have an output module
-
Desktop Tester
$42,500.00The 14S provides immediate, accurate readings of many types of property measurements. By being able to measure static and dynamic friction coefficients, adhesion, scratch hardness, stickiness, tensile strength, and peel resistance with one unit, lab space is minimized and a consistent interface for measurements and data collection are provided. Various tests can be performed by changing test fixtures (jigs). This system does not include the ability to output data.
-
Static Friction Tester
$12,500.00Install a test piece onto the ascending board under the flat indentor. The ascending board is equipped with a sensor that monitors the motion of the flat indentor.
The ascending board is normally in the horizontal position. The board inclines and the sensor detects motion when the flat indentor starts sliding. The system is then stopped and the angle is measured to calculate the coefficient of static friction.