Wear and Surface Property Analyzers

Rotating Drum System

Used to inspect friction between a rotating surface and sheets, the H16 can be used for textile, film and paper measurement, as well as assessing friction and wear characteristics of coated or plated surfaces (on the drum). The sheet of test material is placed over 1/8 to 1/2 of the drum's diameter. A load is applied to the sheet and the other end connected to a strain gauge. When the drum rotates, friction occurs and its resistance is detected and displayed.

SKU H16 Categories Friction, Wear and Surface Property Analyzers

$48,500.00

Scratch Tester

Scratch resistance is calculated as the result of continuous loading. A scratch needle is loaded onto the test surface. The mobile base holding the test piece travels with the applied load. When the scratch or film peeling begins, the vertical load can be calculated as the distance to the failure point can be precisely measured. Various needle diameters and materials can be used to properly test almost any surface. Scratch hardness an be measured by using a fixed load instead of the continuous load module. This system includes an analog output and PC data collection system.

SKU H18L Categories Friction, Wear and Surface Property Analyzers

$22,700.00

Scratch Tester

OBS - This instrument has been replaced by our H18L Scratch resistance is calculated as the result of continuous loading. A scratch needle is loaded onto the test surface. The mobile base holding the test piece travels with the applied load. When the scratch or film peeling begins, the vertical load can be calculated as the distance to the failure point can be precisely measured. Various needle diameters and materials can be used to properly test almost any surface. Scratch hardness can be measured by using a fixed load instead of the continuous load module. This system does not have an output module

SKU H18 Categories Friction, Wear and Surface Property Analyzers Tag obsolete

$17,500.00

Static Friction Tester

Install a test piece onto the ascending board under the flat indentor. The ascending board is equipped with a sensor that monitors the motion of the flat indentor. The ascending board is normally in the horizontal position. The board inclines and the sensor detects motion when the flat indentor starts sliding. The system is then stopped and the angle is measured to calculate the coefficient of static friction.

SKU H10 Categories Friction, Wear and Surface Property Analyzers

$12,500.00

Surface Property Tester

Benchtop low cost surface property tester including a 1000gf loadcell, Sapphire needle(0.05R 90 degrees x 1), Vertical gauge for sapphire needle(1), a set of combination deadweight, Power cable(1), Acrylic resin cover(1), Parts box(1), Tool spanner(1) and Operating instruction manual(1). Commissioning and Tribosoftware w/PC are not included. The set of combination deadweight includes 200gx1, 100gx2, 50gx1, 20gx1, 10gx2, 5gx1, 2gx1 and 1gx1.

SKU H38 Categories Friction, Wear and Surface Property Analyzers

$28,900.00

Wide-Range Load Friction and Wear Tester

Now with it's wider range measurement range, the H35 allows for testing from a minimum of 20g to a maximum of 100kg. This allows for optimal rotational wear testing due to its ability to address low and high speeds. The H35 can conduct a single test up to a maximum of 9,999,999 times. The H35 also utilizes a non-contact type of thermometer with an interlocking system as its opening and closing type (safety cover).

SKU H35 Categories Friction, Wear and Surface Property Analyzers

$94,500.00